engraving machine for gears

PLC control engraving machine can mark the gears, valves, bearings and some other engine parts, fast and accurate marking
Name:QLCP-V PLC Portable Engraving Machine
Technical Parameters
Power supply: AC220V
Total power:388W
Output power:320W(Dual-power output to prolong the life of power parts)
Marking voltage: 0-25V
Marking current:12.8A
Static power: less than 30W
Marking timing range:0.1s-9s
Marking frequency counter: 1－200000

Marking water flow rate
:
0.01ml-10ml(adjustable)
Stencil counter: 1－10000

water counter: 1-100000
Max. marking amount:2300pcs/hour
pressure:0.2-1Mpa.

1. Flexible and easy for marking on products;
2. Higher integration of PLC and lower fault rate;
3. 16-bit PLC to realize higher control accuracy in the marking process;
5. Over-current protection for marking voltage (alarming in case of more than approx. 13A) to prolong the service life of marking power parts;
6. Over-voltage protection for marking voltage (alarming in case of more than approx. 15V) to prevent the stencil plate from burning due to higher voltage;
7. Accurate marking time by milliseconds;
8. Fully automatic and intelligent supply of marking liquid without manual interfere after setting up;
9. Automatic supply time of marking liquid can be set up in the initialization at will;
10. Alarm in case of a lack of marking liquid in the storage vessel;
11. One-key recovery of ex-factory parameters;
12. One-key storage of user parameters;
13. One-key recovery of user parameters;
14.Touch screen with marking experiences, implies and fault messages and diagnosis for the operators reading as any time to master the optimum marking methods and reduce the consumptions;
15.Dual-power is working to ensure the good quality of the large mark.
16.A start protection circuit for the main board of marking interface to avoid the high pulse into the circuit system of the marking machine when it starts;
17.Filter circuit is built in the main board of marking interface for filtering the peak voltage more than 220V AC;